Triumph Thunderbird Service Manual page 267

Installation
1. Position the sensor to the engine and route the
wiring as noted prior to removal.
Note:
• The air gap for the crankshaft position sensor is
not adjustable.
2. Retain the sensor with the two fixings. Tighten to
6Nm.
3. Refit the hose guide and secure with the fixings.
Tighten to 8 Nm.
~
~~--.l
1. Hose guide
2. Fixings
4. Refit the coolant expansion tank bracket and secure
with the three nuts. Tighten to 3 Nm.
5. Re-route the harness as noted during disassembly,
and reconnect the sensor to the main wiring harness.
6. Refit the alternator cover (see page 18-18>.
Z Refit the swinging arm (see page 14-6>.
8. Refit the left hand side panel (see page 17-9).
9. Reconnect the battery, positive <identified with red
tape) lead first.
10. Refit the rider's seat (see page 17-9).
Fuel System/Engine Management
Throttle Body
Removal
1. Remove the rider's seat (see page 17-8>.
2. Disconnect the battery, negative (black> lead first.
3. Remove the fuel tank (see page TO-86>.
4. Remove the starter motor (see page 18-19).
5. Remove the left hand side panel (see page 17-9).
6. At the twist grip end, release the screw and union
securing the throttle cables to the switch cube.
1. Throttle cables
2. Screw
3. Union
Z Remove the screws securing the right hand switch
cube.
1. Twist grip
2. Screws
SelVice Manual - Thunderbird
10.103