Triumph Thunderbird Service Manual page 264

Fuel System/Engine Management
Manifold Absolute Pressure {MAP}
Sensor
Barometric Pressure Sensor
Removal
cfru
1. Remove the rider's seat (see page 17-8>.
2. Disconnect the battery, negative (black) lead first.
3. Remove the right hand side cover (see page 17-9).
4. Disconnect the electrical multi-plug from the sensor.
1. Remove the rider's seat (see page 17-8>.
2. Disconnect the battery, negative (black) lead first.
3. Raise and support the fuel tank (see page 10-85>.
4. Disconnect the electrical multi-plug from the sensor.
cfpg
1. MAP sensor (right hand shown)
2. Multi-plug
3. Bolt
5. Unscrew the bolt securing the sensor to the intake
duct. 6.
6. Raise the sensor in order to disconnect the hose
from below it.
/
Removal
Installation
Installation
1. Fit the sensor to the intake duct, reconnect the hose
and tighten the bolt to 7 Nm.
2. Reconnect the multi-plug.
3. Lower and secure the fuel tank (see page 10-86).
4. Reconnect the battery, positive (identified with red
tape) lead first.
5. Refit the rider's seat (see page 17-9).
1.
Take a new O-ring and lubricate it with a smear of
petroleum jelly. Fit the O-ring to the sensor, then fit
the sensor to the airbox, tightening the two screws to
3Nm.
2. Reconnect the multi-plug.
3. Refit the right hand side cover (see page 17-9).
4. Reconnect the battery, positive (identified with red
tape) lead first.
5. Refit the rider's seat (see page 17-9).
10.100
Service Manual - Thunderbird