Triumph Thunderbird Service Manual page 262

Fuel System/Engine Management
Installation
1. Reconnect the ECM connectors (see page 10-34).
2. Position the ECM to the airbox.
3. Refit the ECM bracket, ensuring the harness is not
trapped, and secure with the two fixings. Tighten to
7Nm.
4. If fitted, reconnect the SAl hose to the SAl valve.
5. Refit the left hand side panel (see page 17-9).
6. Reconnect the battery, positive (identified with red
tape) lead first.
7. Refit the rider's seat (see page 17-9).
Intake Air Temperature Sensor
Removal
1. Remove the rider's seat (see page 17-8>.
2. Disconnect the battery, negative (black> lead first.
3. Remove the left hand side panel (see page 17-9).
4. Disconnect the electrical multi-plug from the sensor.
' 0 0
90
~
//7;
1. Air temperature sensor
2. Fixing
3. Multi-plug
5. Release the fixing and remove the sensor from the
airbox.
Installation
1. Fit the sensor the airbox and secure with the fixing.
Tighten to 3 Nm.
2. Reconnect the multi-plug.
3. Refit the left hand side panel (see page 17-9).
4. Reconnect the battery, positive (identified with red
tape) lead first.
5. Refit the rider's seat (see page 17-9).
10.98
SelVice Manual - Thunderbird