Removal; Installation; Input And Output Shaft Assemblies - Triumph Rocket III Service Manual

Transmission
Installation
1. Place a new torsional damper shaft housing
gasket over the crankcase.
Note:
• The gear position indicator shaft can also
be filled after installing the torsional
damper shaft housing.
2. Install the gear position indicator shaft, engaging
the inner drive slot with the selector drum.
3. Locate the damper assembly to the crankcases
and push fully home, engaging the meshing
gears as you do so.
4. Fit and tighten the damper housing bolts to
28Nm.
5. Fit a new O-ring to the gear position sensor.
Lubricate the O-ring with petroleum jelly.
6.
Fit the gear position sensor and tighten its fixings
to 9 Nm.
Input and Output Shaft Assemblies
Removal
Note:
• The input and output shafts may be
removed from the upper crankcase after
first separating the lower crankcase from
the upper.
Note:
• The rear bearing on the input shaft
remains in the crankcase on removal of the
shaft.
1.
Remove the engine from the frame as described
on page 10.2.
2. Separate the lower crankcase from the upper as
described on page 5.5.
Note:
• The output shaft may be retained in the
lower crankcase on separation from the
upper. If the output shaft is not retained In
the lower crankcase, make a note of the
position of each selector fork on the
output shaft.
3. Lift the output shaft from the upper crankcase
noting the orientation of each bearing and their
circlips.
4. Remove the selector shaft and forks as
described on page 8.7.
Note:
• The input shaft bearing housing fixlngs
may not be reused but should be retained
for use during installation of the input
shaft.
8.12
Service Manual - Rocket III