Removal - Triumph Thunderbird Service Manual

Clutch
Z Align the dot on the gear change actuator arm with
the dot on the gear change shaft and fit the actuator
arm to the spline. Fit the bolt and tighten to 9 Nm.
1. Gear change actuator arm
2. Fixing
3. Actuator arm dot mark
4. Gear change shaft dot mark
8. Refit and adjust the clutch cable (see page 4-5>.
Clutch
Removal
Before starting work, ensure the motorcycle is stabilised
and adequately supported. This will help prevent it from
falling and causing injury to the operator or damage to
the motorcycle.
1. Remove the clutch cover (see page 4-6).
2. Undo the bolts, withdraw the springs and remove
the clutch pressure plate.
:fup
1. Pressure plate bolt
2. Spring
3. Pressure plate
3. Remove the lifter piece and roller bearing from the
clutch pressure plate.
1. Lifter piece
2. Roller bearing
3. Clutch pressure plate
4.8 SelVice Manual - Thunderbird