Triumph Thunderbird Service Manual page 93

Clutch
6
\
1. Circlip
2. Centre nut
3. Belleville washer
4. Plain washer
5. Inner drum
6. Thrust washer
7. Outer drum
10. Discard the Belleville washer and the plain washer.
11.
Remove the torque compensator (see page 5-20>.
12. Slide the clutch outer drum off the gearbox input
shaft.
1. Service tool T3880043
8. Release the clutch centre nut.
9. Remove the centre nut, Belleville washer, plain
washer, clutch inner drum and thrust washer.
7.
Lock the inner and outer clutch drums together
using service tool T3880038.
4. Remove all the clutch friction plates and steel plates
together with the anti-judder seat washer and spring.
Note the orientation of all components as they are
removed.
Note:
• The outermost friction plate is different to the
remainder. It must not be fitted in any other
position.
• Refer to the following page of this section for
details of clutch friction plate inspection.
• It is not normally necessary to disassemble the
clutch further, but if the clutch inner and outer
drums are to be removed, proceed as follows:
S. Remove and discard the circlip from the gearbox
input shaft.
6. Lock the clutch to the torque compensator, using
service tool T3880043 located above the clutch as
shown below.
1. Torque compensator
2. Clutch primary gear
3. Service tool T3880043
SelVice Manual - Thunderbird
4.9