Triumph Thunderbird Service Manual page 104

25. Refit the oil pump (see page 8-14).
26. Refit the water pump (see page 11-7>.
2Z Refit the sump (see page 8-11>.
28. Refit the alternator (see page 18-1B>.
29. Refit the clutch (see page 4-10>.
30. Refit the torque compensator (see page 5.20>.
31. Refit the gear position sensor (see page TO-101).
32. Refit the engine to the frame (see page 9-5>.
1. Output shaft bearing retainer
2. Seal
3. O-ring
23. Refit the output shaft bearing retainer plate.
24. Install new fixings and tighten in two stages in the
sequence shown below.
Tighten the fixings to 3 Nm.
Tighten the fixings to 10 Nm.
22. Fit a new output shaft bearing retainer plate O-ring
to the groove in the crankcase.
@
@
ITl\
FJ
o/J\\~fi=J
1. Bearing retainer plate
2. Fixings
21. Install a new oil seal in the output shaft bearing
retainer plate.
~
1. Breather drain tube
2. Fixing
lZ Refit both control plate mounting brackets to the
lower crankcase. Tighten the left hand fixings to
40 Nm, and the right hand fixings to 28 Nm.
18. Fit a new oil filter (see page 8-7>.
19. Refit the input shaft bearing retainer plate.
20. Install new fixings and tighten to 12 Nm.
15. Fit a new O-ring and install the breather drain tube
to the crankcase. Ensure the tube is correctly
installed in the breather housing.
16. Install a new fixing and tighten to 12 Nm.
5.8
SelVice Manual - Thunderbird