Privacy/Security; Activating And Deactivating The Ringer; Activating And Deactivating The Ringer Permanently Or Setting To Beep - Unify OpenStage 15 User Manual

Privacy/security

Ringer off
Privacy/security

Activating and deactivating the ringer

Activating and deactivating the ringer permanently or
setting to beep
If you do not want to be disturbed by the phone ringing for an incoming call, you
can deactivate the ringer permanently or set it so that you are only advised of a
call by a beep every 25 seconds. You can also configure the settings while the
phone is ringing.
)
Hold down the key (approx. 2 seconds) until the "Ringer off" icon appears on the
status bar on the display (
The ringtone is deactivated.
)
To switch the function off again, hold down the key until the "Ringer off" icon
disappears from the status bar on the display.
You can also switch the function on and off using the option in the idle menu.
Select and confirm the option shown.
f
Setting the ringer to a beep
)
Hold down the key (approx. 3 seconds) until the "Beep" icon appears on the
status bar on the display (
25 seconds for as long as the caller stays on the line.
)
To switch the function off again, hold down the key until the "Beep" icon
disappears from the status bar on the display.
or
Deactivating the ringtone with a key
Prerequisite: The "Ringer off" key must be programmed (
S
Press the "Ringer off" key.
An incoming call is signalled by a single ringtone burst.
R
Press the illuminated key once more to deactivate the "Ringer off" function. The
beep cannot be set using the key.
Page 24).

Page 24). You will hear a short beep every

135
Page 69).
