Undo Edit - SoundCraft Vi5000 User Manual

®
Vi5000/7000 User Manual
EDIT & LIBRARY > COPY, PASTE, UNDO
• Copy FX
To make selection of the source and destination Lexicon FX units easy, a set of eight FX-select encoders appears on
the central screen in both Copy and Paste modes. The selection is made by either touching the relevant encoder or
pressing the corresponding Vistonics button beside the encoder. If the FX unit is assigned to a channel or bus then the
units can be selected by touching the FX block on the channel strip.
Note that only the parameters relating to the currently active FX Type are copied/pasted for each unit. For example, if
LEX1 is selected, and is currently set to the Small Hall FX type, then only the Small Hall parameters will be copied.
Paste
Enter paste mode to Paste any channels, processing blocks, parameters, or Lexicon FX settings
(selected in Copy mode) to a new destination.
To paste anything selected in Copy mode, press [Paste] to enter Paste mode, then select the destination channel
by pressing its [SOLO/SEL] button or touching any VST field on the channel. The clipboard content is immediately
copied to each selected channel.
Once you have finished, press the [PASTE] button again to exit Paste Mode and enter normal operation.
IMPORTANT! Remember to switch PASTE mode off immediately after use, otherwise accidental pasting of the
clipboard will occur the next time you touch a screen or press a Solo/Sel button.

Undo Edit

Undo the last paste operation.
The Paste button must be switched ON in order to use the UNDO function.
13.1: COPY, PASTE, UNDO
13.1: COPY, PASTE, UNDO