SoundCraft Vi5000 User Manual page 211

Network Config: This tab enables viewing and
editing of Dante Redundancy mode.
Switched Mode ‐ When set to Switched, the
secondary Ethernet port will behave as a
standard switch port, allowing daisy‐chaining
through the device.
Redundant Mode ‐ When set to Redundant,
the device will duplicate Dante audio traffic
to both Ethernet ports, allowing the
implementation of a redundant network via
the secondary port. In this case care must be
taken to avoid accidently making any
connection between the two parallel
networks.
Note: All devices on a Dante network MUST
be set to the same Mode (Switched or
Redundant), otherwise the network will not
function reliably.
Dante Presets
Although patching to and from the Dante card in the console is stored as part of a show or part of a
cue the configuration and routing of the Dante cards and Dante audio streams is not.
In the event a Dante card is replaced or
similar, the 'new' card will require
configuring, this may be done manually or by
loading a previously stored preset from the
'File' menu of the Dante Controller software
Vi Dante Card User & Setup Guide V1.1