Show; Export And Import; New Show; Edit Show - SoundCraft Si3 User Manual

SHOW

EXPORT and IMPORT

Only one Show can be stored on the console itself, this one being the currently-loaded show. If the console is
powered off, and then powered on again the show which was loaded at power- off will automatically be re-
loaded when the console is powered-on again.
In order to save more than one show a USB memory device must be inserted.
The EXPORT and IMPORT pads are only availale if a USB memory device is plugged into the socket on the left
of the touchscreen.
The EXPORT PAD copies the currently-loaded show to the USB device. When it is pressed the user is presented
with an on-screen keyboard in order to enter the name which will be given to the exported show. The same
show can be saved multiple times, each time with a different name.
The IMPORT PAD will open a page showing the shows stored on the USB device. The ADJUST knob will allow
selection, pressing the knob will load the selected show into the console.

NEW SHOW

Pressing the NEW SHOW pad will delete the currently-loaded show from the console's memory, and load a
new blank (no snapshots) show . If the old show hasn't been exported to a USB device it will be lost.

EDIT SHOW

Pressing the EDIT SHOW pad will open the following page. It allows the user to Change the name of the show
and also to edit which parameters will be recalled by the automation.
Page 6 - 4 Soundcraft® Si3 User Guide