SoundCraft Vi5000 User Manual page 42

®
Vi5000/7000 User Manual 6.2: CHANNEL STRIP
INPUT CHANNEL > CHANNEL STRIP
Input Isolate
Used to isolate the channel (and selections) from snapshot recall and (when Global Filtering is
active) from Show file loads.
See the Snapshot and Global Filtering reference section 14 for more information.
Level and GR Meter
Level and gain reduction metering for the input channel.
See the metering reference section 12 for more information.
Input Channel Label
Displays the short label/name of this channel.
The long and short channel labels are set in the channel's 'Input' Vistonics parameter block. See reference section
6.5.1 for more information.
'Pre' Indicator
Bus send routing indicator.
When Bus sends are assigned to channel faders, using FLW mode, the PRE indicator lights to indicate when the
send is set to a Pre-fader source.
Channel ON/OFF
Channel [ON]/OFF button. 'OFF' is effectively a mute control.
The button glows green when the channel is 'On'. If the channel is off there is no glow colour. However, if the
channel is muted because a mute group has been activated, the [ON] button will glow red.
MUTE SAFE indicator
Indicates when the channel has been set to MUTE SAFE mode from the Monitor Setup menu
(refer to Chapter 10).
When set to MUTE SAFE, a channel can still be manually muted by pressing the ON/OFF button, but cannot be
muted by 'remote' actions such as Mute or VCA group operation, snapshot recalls or activation of a Solo in Place
(SIP) from another channel.
6.2: CHANNEL STRIP