SoundCraft Vi5000 User Manual page 198

®
Vi5000/7000 User Manual 18.1.1: HiQnet DEVICE LIST
VM ² > HiQnet CONFIGURATION > DEVICE LIST
MAP Devices (Scroll List)
Scroll through the list of available VM² devices.
Hint: To avoid opening and closing the Audio Patch page, the MAP DEVICES encoder can still be used to scroll
through the Device List even whilst the Audio Patch page is still open. The name (truncated) of the currently
selected Device can be seen in above the MAP DEVICES Vistonics scroll encoder.
Locate Devices
Activate the Locate function on the selected AKG receiver.
Pressing (LOC) will cause the front panel display of the chosen receiver to flash, allowing it to be more easily
identified among a rack of others.
Patch Devices
Activate the VM² microphone patching screen.
The patching matrix allows all of the physical input connectors available within the Vi system to be seen and the
relevant connector to be chosen to correspond to where the currently selected microphone is connected.
The chosen connector is shown in bright blue highlight, whereas connectors that are already associated with
other AKG or Shure devices are shown as greyed-out. A greyed-out connector can still be chosen as an assign-
ment for the
currently selected microphone, but a dialogue box will appear in this case to ask if you wish to reassign this
connector.
Wireless
Activate wireless system detection.
When on, the console will auto-detect Shure wireless systems. When off, detection of receivers is not possible;
any previously detected units will be disabled and will be shown as greyed-out in the Device list. To discover AKG
devices, use the HiQnet button.
18.1.1: HiQnet DEVICE LIST