Setup; Data Socket; Store; Undo - SoundCraft VI6 User Manual

SETUP

The [SETUP] key causes the Setup page to be displayed on the master screen, see Figure 15-3.

DATA Socket

This accepts a USB data storage device. There are three data sockets on the console: the other two are
located on the rear panel.

STORE

Pressing [STORE] will record the console's current settings into a new snapshot. The precise effect this key
has depends upon the setting of the Generate Cues {AUTO} key in the SETUP page (see Figure 15-3). If
the Generate Cues {AUTO} key is off then only Snapshots will be recorded. If the key is on then a new Cue
will also be recorded which points to the new Snapshot.

UNDO

Pressing [UNDO] will undo the effect of pressing [RECALL], [NEXT] or [LAST]. It is useful if any of these 3
keys get pressed by mistake, and if the console's previous settings, which will get overwritten, are needed
and have not yet been recorded into a snapshot.

PREV MODE

This is reserved for future use.

LAST

The [LAST] key is used in conjunction with the information displayed in the Cue List (see Figure 15-1).
Pressing [LAST] causes any settings pointed to by the previous Cue, in the Cue List, to be loaded into the
desk, i.e. the desk is configured according to the settings held against the previous Cue. This Cue becomes
the current one in the list.

NEXT

The [NEXT] key is used in conjunction with the information displayed in the Cue List (see Figure 15-1).
Pressing [NEXT] causes any settings pointed to by the next Cue, in the Cue List, to be loaded into the desk,
i.e. the desk is configured according to the settings held against the next Cue. This Cue becomes the
current one in the list.

The Arrow Keys and RECALL

The [up arrow] and [down arrow] keys are used in conjunction with the information displayed in the Cue
List (see Figure 15-1). Pressing either of these keys will scroll up or down the list, without implementing
the settings of any of the Cues which are being scrolled through.
When the required Cue is reached, the user presses [RECALL]: this causes any settings pointed to by the
selected Cue to be loaded into the desk, i.e. the desk is configured according to the settings held against
this Cue. This Cue becomes the current one in the list.
Page 15 - 2 Soundcraft Vi6™ User Guide