SoundCraft Vi5000 User Manual page 142

®
Vi5000/7000 User Manual 15.1: TBACK & OSC CONTROLS
TALKBACK & OSCILLATOR > CONTROLS
Talkback And Oscillator Setup
Open and close the Talkback and Oscillator setup screen in the master Vistonics screen.
Talkback XLR Connector
The Talkback Mic input.
This connector is duplicated on the rear panel of the surface. There is a switch for phantom power adjacent to the
rear panel Talkback Mic connector if required.
Talkback / OSC Level Control
Control of Talkback or Oscillator level.
For Talkback, the analogue Mic Amp gain is variable from 46-66dB by 3 internal jumpers which are located on
the PCB that is located adjacent to the rear-panel talkback mic connector.. This is set by default to a mid-range
setting. If the Oscillator is active, the control adjusts the Osc level to all destinations. The level setting is stored
independently for TB and Osc. The front-panel Talkback/Osc level control applies an additional digital gain trim to
the talkback mic signal.
Talkback To Internal
Route the Talkback signal to pre-selected output busses.
The 'INT' routed Output busses are selected via their {TB} VST keys in the VST area of the master screen after
selecting the [TB ASSN] key (located to the right of the master screen's VST area). Switch between the two sets
of 16 busses with the [PAGE A] and [PAGE B] keys.
15.1: TALKBACK & OSCILLATOR CONTROLS