Delay Feedback - SoundCraft Vi5000 User Manual

®
Vi5000/7000 User Manual
LEXICON FX > DELAYS
Tap Ratio
Controls the Tap ratio of left and right outputs relative to the Delay time.
Specific to the Pong Delay effect, this controls the delay time offset between left and right taps, expressed as a
ratio of left to right time difference. In the centre the taps have the same time (1:1).
Tap Swap
Swaps the delay time tap offset set by the Tap Ratio.
Specific to the Pong Delay effect - reverses the offset set by the Tap Ratio control.

Delay Feedback

Controls the number of delay repeats by feeding the delay output signal back into the delay input.
This creates a series of delay repeats, each slightly attenuated until they become inaudible. Higher settings create
more repeats; lower settings reduce the number of repeats. When this knob is turned fully clockwise, it engages
Repeat Hold – delay repeats play back in an infinite loop, but no further input signal is introduced into the delay
effect. Repeat Hold is available only on Studio, Mono and Pong Delay.
Low Cut Filter Frequency
Frequencies below this level are attenuated.
High Cut Filter Frequency
Frequencies above this level are attenuated.
Smear
Ducking attenuation amount.
Available only for Tape and Reverse Delays, this parameter controls the amount of "smear," or signal degradation
and frequency loss. The higher the setting, the more each delay repeat loses intelligibility compared to the original
signal.
17.2.2: DELAYS
17.2.2: DELAYS