SoundCraft Vi5000 User Manual page 131

®
Vi5000/7000 User Manual 14.3.3: MIDI CUES
CUES > MIDI
MIDI In Message Learn
Activate Learn mode for MIDI input message type.
When LEARN mode is active, the next MIDI message received will be entered into the MIDI message fields.
MIDI Input Channel or Device ID
Select a MIDI device as the recall trigger 'carrier'.
Depending on the type of MIDI message selected, either a MIDI channel (1-16), or a Device ID (1-127) control will be
presented. MIDI devices are set up in the master MIDI Settings section, though default to numbered (and availa-
ble) MIDI inputs and channels. A Global device is also available, which defaults to 'OMNI' but can be customised in
the master MIDI settings section.
MIDI Output Enable/Disable
Enable or Disable MIDI output for this cue.
A Cue's MIDI output consists of a message event list that is transmitted when the cue is triggered.
MIDI Output Event Number
Set the MIDI output event number to be edited.
There are up to 20 MIDI output events available for each cue. The encoder scrolls through the list of events and
allows the parameters for each event to be set up using the associated Vistonics controls.
MIDI Output Event List
When selected, the MIDI event list for this cue is displayed in the 'snapshot scope' section of the
snapshot settings screen.
Up to 20 output MIDI events can be set up for simultaneous recall from each Cue. Opening the event list allows
the event settings to be viewed simultaneously as well as whether each of the 20 events is enabled or disabled.
MIDI Out Event Message Type
Select a message type for the selected MIDI event.
New VST area fields will be activated depending on which MIDI message type is selected. For example, if a Note
On message is selected, the {NOTE VALUE} and {VELOCITY} fields will be available. If a Controller message is
selected, then {CONTROLLER NUMBER} and {VALUE} will be available. When any valid message is selected, the
{CHANNEL} field becomes available.
14.3.3: MIDI CUES