Huawei OceanStor VIS6000 Series Command Reference Manual page 71

OceanStor VIS6000 Series Virtual Intelligent Storage
System
Command Reference
Parameters
Parameter
-c controller ID
-i netport ID
Modes
Normal.
Level
Guest level.
Usage Guidelines
When using the command, pay attention to the following points:
l
l
Example
View the information about all the network interfaces on controller B.
VIS CLI:root>device>shownetport -c 1
================================================================================
================================================================================
*************************************** ****************************************
* Controller ID
* Type
* Netport ID
* Running Status
* Rate(Mbps)
Issue 06 (2010-05-10)
You can view the information about all the network interfaces on a specified controller by
running the command shownetport -c controller ID.
You can view the information about a specified network interface on a specified controller
by running the command shownetport -c controller ID -i netport ID.
1
Manage
2
Online
100
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Description
Specifies the ID of the
controller where the
network interface is.
Specifies the ID of the
network interface.
Netport Info
* * Controller ID
* * Type
* * Netport ID
* * Running Status
* * Rate(Mbps)
2 Commands
Value
The value options are 0 and 1.
They are described as follows:
0: indicates controller A.
l
1: indicates controller B.
l
The value options are 0, 1, 2, and
3. They are described as
follows:
0: indicates heartbeat
l
network interface 1.
1: indicates heartbeat
l
network interface 2.
2: indicates management
l
network interface.
3: indicates configuration
l
network interface.
1
Configuration
3
Offline
100
*
*
*
*
*
2-39