Huawei OceanStor VIS6000 Series Command Reference Manual page 259

OceanStor VIS6000 Series Virtual Intelligent Storage
System
Command Reference
Function
To change the link status of an FC service port in the fault simulation test.
Format
chgfclinkstatus -c controller ID -i interface ID -p port ID -s status
Parameters
Parameter
-c controller ID
-i interface ID
-p port ID
-s status
Modes
Normal.
Level
Administrator level.
Usage Guidelines
You can set the link status of an FC service port by running the command chgfclinkstatus -c
controller ID -i interface ID -p port ID -s status.
Issue 06 (2010-05-10)
Description
Specifies the ID of the
controller that an FC service
port belongs to.
Specifies the ID of an interface
card.
Specifies the ID of an FC
service port.
Specifies the link status of an
FC service port.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Value
The value options are 0 and 1. They
are described as follows:
0: indicates controller A.
l
1: indicates controller B.
l
The value options are 0, 1, and 2.
They are described as follows:
0: indicates interface module 0.
l
1: indicates interface module 1.
l
2: indicates interface module 2.
l
The value options are 0, 1, 2, and 3.
They are described as follows:
0: indicates FC service port 0.
l
1: indicates FC service port 1.
l
2: indicates FC service port 2.
l
3: indicates FC service port 3.
l
The value options are 0 and 1. They
are described as follows:
0: indicates the disconnected
l
status.
1: indicates the connected status.
l
2 Commands
2-227