The Display Panel During Build; Chamber Lights; Pausing Build - µ-Dimension SST 1200es User Manual

The Display Panel During Build:

The top two lines of the display panel show printer-status messages
(see Figure 14). The bottom line of the panel shows the material
amounts remaining in the cartridges.
NOTE: If a material amount is flashing, it indicates that the
remaining material will NOT be sufficient to complete
the current build.
Printer Status
Model File Name
Model Material
Remaining
Support Material
Remaining

Chamber Lights

When a part starts to build, the chamber lights are automatically ON.
You can toggle lights ON or OFF through the Display Panel.
You can also turn the light on continuously. Go to the Idle or
Ready to Build mode. Press Maintenance and then press
Next until Setup Maintenance is displayed. Press Lights
Always. The light will remain ON until the system is powered OFF.

Pausing Build

While building a part, you may want to pause the operation - e.g, to
allow for replacement of a material cartridge. To pause the build
operation at any time, press Pause.
When the build process is paused, Dimension completes the current
tool path before pausing. This may take several minutes.
Figure 14: Display panel during build
NOTE
Dimension BST 1200es / SST 1200es User Guide
Operation 41