Disassembling Crankcase Half - Arctic Cat 2009 366 Service Manual

Disassembling
Crankcase Half
1. Remove the secondary and primary driveshaft
assemblies. Account for the bearing alignment
C-ring on the bearing boss next to the driven gear.
NOTE: Note the location of the bearing alignment
pin on the secondary output shaft.
2. Remove the reverse idler gear, spacer, and sleeve.
Account for the washer.
3. Remove the driveshaft.
Back
3-36
MD1313
MD1317
MD1325
Back to TOC
4. Remove the shift fork shaft and the outer shift fork.
5. Remove snap ring and gear from the output side of
the gear cluster. Remove the gear cluster and the
inner shift fork together. Account for snap ring,
gear, and washer.
6. Noting the position of the slot on the end, remove
the shift cam assembly. Account for inner and
outer washers.
Back to Section TOC
MD1326
MD1327
MD1328
Next