Arctic Cat 2009 366 Service Manual page 60

12. Install the air intake plate. Apply red Loctite #271
to the threads of the three Phillips-head cap
screws; then install and tighten securely.
13. Place the driven pulley assembly into position and
secure with the nut (threads coated with red Loc-
tite #271). Tighten to 147 ft-lb.
Back
3-34
MD1117
MD1342
MD1068
KC134
Back to TOC
14. Slide the fixed drive face assembly onto the front
shaft.
15. Spread the faces of the driven pulley by threading
a V-belt cover cap screw into the fixed driven face
and tightening until the faces open sufficiently to
allow the V-belt to drop into the pulley approxi-
mately 3/4 in.
NOTE: The arrows on the V-belt should point in
direction of engine rotation.
16. Making sure the movable drive face rollers are in
position, pinch the V-belt together near its center
and slide the spacer and movable drive face onto
the shaft.
17. Coat the threads of the nut with red Loctite #271;
then making sure the splines of the clutch shaft
protrude through the cover plate, secure with the
nut and tighten to 147 ft-lb.
Back to Section TOC
KC137
KC127
KC138
Next