Arctic Cat 2009 366 Service Manual page 103

Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of
the snap ring faces to the outside.
Back
6-6
AF984
KX219
AF993
AF994
Back to TOC
2. Install the input shaft seal making sure it is flush
with the edge of the housing.
3. Lubricate the input shaft splines with High-Perfor-
mance #2 Molybdenum Disulphide Grease.
NOTE: Any time drive splines are separated,
clean all splines with parts-cleaning solvent and
dry with compressed air; then lubricate with rec-
ommended grease.
4. Install the input shaft into the housing; then install
the front boot and secure with an appropriate boot
clamp and the rear boot with an appropriate boot
clamp.
5. Using a new O-ring lubricated with grease, install the
front drive actuator and secure with the cap screws.
6. Place the pinion housing with new gasket onto the
gear case housing; then secure with the existing
cap screws. Tighten to 23 ft-lb.
Back to Section TOC
KX221
KX222
CD112
Next