Arctic Cat 2009 366 Service Manual page 114

2. Using the boot clamp pliers, secure the small
clamp of the inner boot.
3. Apply 80 grams (2/3 of contents) of grease from
the pack into the bearing housing.
4. Install the bearing onto the shaft making sure the
recess of the bearing is facing the housing.
! CAUTION
The bearing ring must go onto the shaft with the side
without splines facing toward the small clamp of the
inner boot or severe damage will result.
5. Secure the bearing ring with the snap ring making
sure the sharp side of the snap ring faces away
from the boot.
Back
CD754
ATV-1048
CD022
Back to TOC
6. Making sure the marks made during disassembling
align, slide the housing over the bearing ring; then
completely seat the bearing ring into the housing
and install the circlip.
NOTE: Pull the bearing ring out of the housing
until it contacts the circlip; then slide the ring in
half way. This will purge air from the housing and
ensure the bearing is packed properly.
7. Slide the boot over the housing; then using the
boot clamp pliers, secure the boot with the clamp.
8. Inspect the axle components for correct position-
ing of the four clamps. Also, inspect the boots for
being correctly positioned on the shaft.
INSTALLING REAR DRIVE AXLE
1. Slide the drive axle into place in the gear case.
Back to Section TOC
CD023
6
CD021
CD024
Next
6-17