Arctic Cat 2009 366 Service Manual page 69

4. Install the front and rear V-belt cooling boots and
secure with the existing hardware.
5. Connect the stator coil, trigger coil, and gear shift
position switch connectors; then attach the engine
ground cable and starter cable and secure with cap
screws and nuts. Tighten to 8 ft-lb.
Back
KC242
KC243
KC235
KC236
Back to TOC
6. Set the inlet air silencer into the frame; then install
the exhaust pipe using a new exhaust pipe seal and
grafoil seal. Tighten the cap screws evenly to 20
ft-lb and install the muffler retainer springs.
Back to Section TOC
KC228A
3
KC228B
KC237
KC238
Next
3-43