Lcd Gauge - Arctic Cat 2009 366 Service Manual

INSTALLING
1. Place the return spring into the throttle control;
then place the bushing and actuator arm into posi-
tion. Secure with the cap screw, lock washer, and
washer.
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
3. Place the two halves of the throttle control onto the
handlebar and secure with the two machine
screws.
ADJUSTING
To adjust throttle cable free-play, see Section 2.
Back
AF678D
AF679D
AF680D
Back to TOC

LCD Gauge

REPLACING
To replace the LCD gauge, use the following proce-
dure.
1. Remove the electric panel and disconnect the LCD
gauge connector; then remove three mounting
screws (two in front and one in back of gauge) and
remove the gauge.
2. Install the new gauge and secure with the mount-
ing screws; then connect the gauge to the main
harness and install the electric panel.
Back to Section TOC
KC210G
KC323A
9
9-3