Arctic Cat 2009 366 Service Manual page 77

11. Inspect the float valve for wear or damage.
12. Inspect the carburetor mounting flange for damage
and tightness.
ASSEMBLING
1. Thread the idle adjust screw into the carburetor
making sure the washer and spring are properly
positioned.
2. Install the pilot screw, spring, washer, and O-ring.
NOTE: Turn the pilot screw clockwise until it is
lightly seated; then turn it counterclockwise the
recommended number of turns as an initial set-
ting.
NOTE: Note the locations of the jets and holder
during assembling procedures.
3. Install the starter jet and slow jet. Tighten securely.
Back
4-6
KC0029A
KC0028A
CC761A
Back to TOC
4. Install the main jet into the needle jet holder and
tighten securely; then install the needle jet and
needle jet holder assembly into the carburetor and
tighten securely.
5. Place the float assembly (with float valve) into posi-
tion and secure to the carburetor with the float pin.
Back to Section TOC
KC0032A
KC0031
KC0030A
KC0024
Next