Arctic Cat 2009 366 Service Manual page 25

5. Pinching the V-belt together in front of the driven
pulley, pull it forward and outward off the clutch
shaft; then remove it from the driven pulley.
6. Inspect the faces of the drive and driven pulleys
for scoring, pitting, cracks, or grooving; then clean
any dirt and debris from the V-belt housing and
cover.
INSTALLING
1. Place the V-belt onto the driven pulley making
sure the arrows point in the direction of rotation;
then pinch the belt together in front of the driven
pulley and place it over the clutch shaft.
Back
2-18
KC137
KC136
KC135
Back to TOC
2. Install the bushing over the clutch shaft; then
install the movable drive face assembly on the
clutch shaft.
3. With two drops of red Loctite #271 on the threads
and with the splines of the clutch shaft protruding
through the movable drive face, install the nut and
tighten to 147 ft-lb.
Back to Section TOC
KC131
KC128
KC138
Next