Arctic Cat 2009 366 Service Manual page 110

NOTE: Prior to installing the seal, apply High Per-
formance #2 Molybdenum Disulphide Grease to
the seal outside diameter.
4. Using an appropriate seal installation tool, evenly
press the seal into the cover bore until seated.
! CAUTION
Make sure the tool is free of nicks or sharp edges or
the seal will be damaged.
5. Repeat steps 1-4 for the opposite side.
INSTALLING DIFFERENTIAL
1. Align the input flange with the front output flange;
then place the differential into position on the
frame and install the cap screws and nuts. Tighten
to 38 ft-lb.
Back
CC901
CF278
KC291A
Back to TOC
2. Install the cap screws securing the flange couplers
together and tighten to 20 ft-lb.
3. Install the front axles (see Drive Axles in this sec-
tion).
4. Install the brake calipers and secure with the
patch-lock cap screws tightened to 20 ft-lb.
Back to Section TOC
AG925
AF610D
6
AF897D
Next
6-13