Arctic Cat 2009 366 Service Manual page 102

1. Remove the cap screws securing the front drive
actuator and remove the actuator; then remove the
cap screws securing the pinion housing.
2. Using a rubber mallet, remove the housing.
Account for a gasket. Remove the fork, collar, and
spring. Note the location of all the components for
assembling purposes.
3. Using a side-cutter (or suitable substitute), remove
the boot clamps; then remove the boots and
splined drive from the input shaft.
4. Remove the input shaft from the pinion housing.
Back
CD102
CD103
CD106
Back to TOC
5. Using a seal removal tool, remove the input shaft
seal. Account for a spacer.
6. Remove the snap ring securing the input shaft
bearing; then place the pinion housing in a press
and remove the bearing.
Back to Section TOC
CD107
AF982
6
AF983
Next
6-5