Arctic Cat 2009 366 Service Manual page 109

2. Using a suitable driver, install the needle bearing
into the gear case housing making sure the bearing
is seated.
NOTE: Do not push the bearing too far into the
housing.
3. Install the pinion shaft and secure with the existing
48 mm lock collar. Tighten to 125 ft-lb.
4. Place a punch on the edge of the lock collar in the
oil gallery area; then using a hammer, stake the
lock collar to ensure that the collar will remain
securely tightened.
Back
6-12
CC888
CC889
CC890
Back to TOC
5. Install the pinion housing.
Removing/Installing Axle Seal
NOTE: This procedure can be performed on a
rear gear case.
1. Remove the seal using a seal removal tool.
2. Using a press, remove the bearing.
3. Using a press, install the new bearing into the
housing.
Back to Section TOC
CC891
CC899
CC900
Next