Arctic Cat 2009 366 Service Manual page 67

6. Keeping the slot directed as shown, install the shift
cam and inner and outer washers.
7. Align the inner shift fork with the gear cluster and
with the inner washer in place, install the gear clus-
ter and inner shift fork. While holding the gear clus-
ter in place, install the washer, gear, and snap ring.
Back
CD826A
KC325
MD1032
MD1198
Back to TOC
8. Install the outer shift fork and the shift fork shaft.
9. Install the input driveshaft.
10. Install the washer, spacer, sleeve, and reverse idler
gear.
11. Install the secondary and primary driveshaft
assemblies. Account for the bearing alignment
C-ring on the bearing boss next to the driven gear.
NOTE: Align the bearing alignment pin on the
secondary output shaft.
Back to Section TOC
MD1327
3
MD1326
MD1357
Next
3-41