Arctic Cat 2009 366 Service Manual page 26

4. Remove the cap screw from the fixed driven face;
then rotate the pulleys counterclockwise until the
driven pulley faces are together.
5. With the two alignment pins installed in the V-belt
housing and a new V-belt cover gasket in place,
install the V-belt cover. Using the pattern shown,
secure with the cap screws tightened to 8 ft-lb.
Back
KC152A
KC141
KC142A
Back to TOC
6. Slide the auxiliary brake pedal fully onto the pivot
stud engaging the master cylinder; then secure
with the flat washer and cap screw and tighten to
20 ft-lb.
Back to Section TOC
KC153A
2
KC149A
2-19