Carburetor - Arctic Cat 2009 366 Service Manual

INSTALLING
1. Lightly lubricate the O-ring on the choke body;
then carefully insert the choke assembly into the
carburetor being careful not to damage the
plunger.
2. Secure the choke with the screw and tighten
securely; then connect the choke connector to the
wiring harness.

Carburetor

KEY
1. Cover
2. Screw
3. Spring
4. Vacuum Piston
5. Spring Seat
6. Jet Needle
7. Needle Jet
8. Jet Holder
9. Main Jet
10. Slow Jet
11. Starter Jet
12. Float Valve
13. Clip
14. Float
! WARNING
Whenever any maintenance or inspection is per-
formed on the fuel system during which there may be
fuel leakage, there should be no welding, smoking,
open flames, etc., in the area.
REMOVING
1. Remove the gas tank (see Gas Tank in this sec-
tion).
2. Disconnect the intake air housing boot from the
carburetor; then slide the intake air housing to the
rear to clear the carburetor.
Back
15. Float Pin 27. Float Chamber
Assy
16. Pilot Screw
28. O-Ring
17. Spring
29. Screw
18. Washer
30. Spring
19. O-Ring
31. Diaphragm Assy
20. Idle Adjust
Screw 32. Pump Housing
21. Washer 33. U-Ring
22. Spring 34. Screw
23. Plate 35. Screw
24. Screw 36. Throttle Cable
25. Electric Choke 37. Cover
26. Choke Cover 38. Screw
39. Vent Hose
Back to TOC
3. Loosen the clamp on the intake pipe and lift the
carburetor up and to the rear; then disconnect the
electric choke connector and vent hose.
0740-600
Back to Section TOC
KC257A
4
KC256A
KC263
KC264A
Next
4-3