Arctic Cat 2009 366 Service Manual page 20

5. Connect the wiring harness connector to the bulb;
then install the protective rubber boot making sure
it seals completely on the headlight harness.
TAILLIGHTS-BRAKELIGHTS
To replace a taillight-brakelight bulb, use the follow-
ing procedure.
1. Turn the bulb socket assembly counterclockwise
and remove from the housing.
2. Press in and turn the bulb counterclockwise to
remove. Press in and turn clockwise to install the
bulb.
3. Insert the bulb socket assembly into the housing
and turn it clockwise to secure.
Back
KC163B
KC146
KC157
Back to TOC
RUNNING LIGHTS/BACK-UP
LIGHTS
The running lights are located outboard of the head-
lights, and the back-up lights are outboard of the tail-
lights/brakelights. To replace the bulbs, use the
following procedure.
1. Rotate the bulb socket counterclockwise to release
from light housing; then press in on the bulb and
turn counterclockwise to release from the socket.
2. Install a new bulb and press in rotating clockwise
to secure; then place the socket into the light hous-
ing and turn clockwise to secure.
CHECKING/ADJUSTING
HEADLIGHT AIM
The headlights can be adjusted vertically and horizon-
tally. The geometric center of the HIGH beam light
zone is to be used for vertical and horizontal aiming.
1. Position the ATV on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming
surface (wall or similar aiming surface).
Back to Section TOC
2
KC158A
KC158B
Next
2-13