Arctic Cat 2009 366 Service Manual page 51

7. Remove the starter idler gear (No. 1) and starter
idler gear (No. 2).
8. Remove the gear shift shaft assembly and washer
from the left-side crankcase. Note the positions of
the alignment marks and washer for installing pur-
poses; then release the cam stopper spring tension.
Back
MD1368
MD1369
MD1370
MD1305
Back to TOC
9. Remove the shift detent cam.
10. Remove the cam stopper assembly.
11. Remove two starter motor cap screws.
12. Remove starter motor by tapping lightly with a
mallet.
NOTE: The starter motor is a non-serviceable
component and must be replaced as an assembly.
13. Using an impact screwdriver, remove the three
Phillips-head screws holding the crankshaft bear-
ing retainer. Remove the crankshaft bearing
retainer.
Back to Section TOC
MD1239
3
KC217
MD1122
Next
3-25