Arctic Cat 2009 366 Service Manual page 56

18. Remove the snap ring holding the oil pump driven
gear.
NOTE: Always use a new snap ring when install-
ing the oil pump driven gear.
19. Remove oil pump driven gear. Account for the
drive pin and thrust washer.
AT THIS POINT
To service clutch components, see Servicing Right-Side
Components sub-section.
H. Oil Pump/Oil Strainer
NOTE: Steps 1-19 in the preceding sub-sections
must precede this procedure.
20. Remove three Phillips-head screws holding the oil
pump and remove the oil pump. Account for two
alignment pins.
Back
3-30
MD1017
MD1019
MD1020
Back to TOC
21. Remove the four cap screws securing the oil strainer
cap; then remove the Phillips-head screws securing
the oil strainer. Account for the O-ring.
AT THIS POINT
To service center crankcase components only, pro-
ceed to Separating Crankcase Halves.
Back to Section TOC
MD1060
MD1207
Next