Front Differential/Rear Drive Lubricant - Arctic Cat 2009 366 Service Manual

11. Remove the oil level stick and wipe it with a clean
cloth.
12. Install the oil level into engine case.
NOTE: The oil level stick should be threaded into
the case for checking purposes.
13. Remove the oil level stick; the engine oil level
should be above the illustrated "L" mark but not
higher than the illustrated "F" mark.
! CAUTION
Do not over-fill the engine with oil. Always make sure
that the oil level is above the " L" mark but not higher
than the " F " mark.
14. Inspect the area around the drain plug and oil filter
for leaks.
15. Install the left-side engine cover and the seat.
STRAINER
1. Remove the belly panel.
2. Remove the cap screws securing the oil strainer
cap; then remove the cap. Account for the O-ring.
3. Remove the two cap screws securing the strainer;
then remove the strainer.
Back
2-10
ATV-0100AA
CC091D
Back to TOC
AT THIS POINT
To check/service oil strainer, see Section 3.
4. Place the oil strainer into position beneath the
crankcase and secure with the cap screws. Tighten
securely.
5. Place the strainer cap into position on the strainer
making sure the O-ring is properly installed; then
secure with the cap screws. Tighten securely.
6. Install the belly panel.
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE
80W-90 hypoid gear lube.
To check lubricant, remove the rear drive filler plug;
the lubricant level should be 1 in. below the threads of
the plug. If low, add SAE approved 80W-90 hypoid
gear lubricant as necessary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil fill plug.
Back to Section TOC
CC163D
CC091D
Next