Shift Cable; Lcd Gauge/Indicator Lights/Dash Switches - Arctic Cat Wildcat ROV 2013 Service Manual

INSTALLING
1. Place the shift lever into position and secure with the
four machine screws (threads coated with blue Loctite
#243). Tighten to 20 ft-lb.
2. Connect the shift cable to the shift arm with the pivot
bolt and tighten the nut to 8 ft-lb.
3. Check shift cable adjustment (see Periodic Mainte-
nance/Tune-Up - Shift Lever/Shift Cable); then install
the center console. Tighten the machine screws
securely.
4. Install the shift lever handle onto the shift lever and
tighten the jam nut with the handle correctly aligned.
5. Install the battery cover and seats.

Shift Cable

REMOVING
1. Remove the seats, battery cover, and center console.
2. Remove the nut (A) from the shift arm pivot bolt: then
loosen the jam nut (B) and lift the cable upward out of
the mounting bracket slot.
3. Remove the E-clip (C); then loosen jam nut (D) and
slide the cable (E) out of the mounting bracket.
4. From under the vehicle, mark any cable tie locations;
then remove the shift cable from the vehicle.
5. If the shift cable is to be replaced, accurately measure
and record the distance between the adjuster nuts (nuts
opposite the jam nuts).
WC348A
INSTALLING
1. Using the measurements from the existing cable,
adjust the adjuster nuts to the same length.
 NOTE: The shift cable will have to be adjusted, but
using the existing measurements will give a close
starting point.
2. From under the vehicle, thread the new cable into
position. Do not tie cable tie points yet.
3. Set the upper cable housing end into the mounting
bracket and finger tighten jam nut (B); then connect
the cable to the shift arm pivot bolt and secure with
the nut (A). Tighten the nut to 8 ft-lb.
4. Place the lower cable housing end into the mounting
bracket on the engine and finger tighten jam nut (D); then
connect cable (E) to the shift arm and install the E-clip (C).
5. Install any necessary cable ties as marked during
removal; then adjust the shift cable (see Periodic Main-
tenance/Tune-Up - Shift Lever/Shift Cable). After cable
is properly adjusted, tighten the jam nuts to 20 ft-lb.
6. Install the center console, battery cover, and seats.
LCD Gauge/Indicator
Lights/Dash Switches
REPLACING
1. Remove the hood and grille (see Hood in this section).
2. Remove the four screws securing the upper dash to the
frame.
WC348B
WC178B
WC329A
189