REASSEMBLY AND INSTALLATION
Reassemble and install the front fork in the reverse order of
removal and disassembly. Pay attention to the following points:
%
* Thoroughly wash all the component parts being
assembled.
* When reassembling the front fork, use new fork oil.
* Use the specified fork oil for the front fork.
* When reassembling, replace the oil seal, dust seal
and damper rod bolt gasket with new ones.
• Insert the oil seal 1 to the outer tube.
NOTE:
Apply fork oil to the oil seal 1 lip lightly before installing it.
, 99000-99044-10G: SUZUKI FORK OIL G10
OIL SEAL
• Install the oil seal 1 into the outer tube using the front fork oil
seal installer.
$ 09940-52861: Front fork oil seal installer set
%
* Wash clean the front fork oil seal installer before
using. If dirt is on the installer, the inner tube may
possibly be damaged during press-fitting work.
* When install the oil seal, the stamped mark on the oil
seal must face upper side.
• Install the oil seal stopper ring 2 and dust seal 3.
%
Make sure that the oil seal stopper ring is fitted
securely.
DAMPER ROD
• Fit the rebound spring 1 to the damper rod 2 and install
them to the inner tube.
or equivalent fork oil
http://mototh.com
CHASSIS
5-35