Suzuki UY125 Service Manual page 76

3-42 ENGINE
DRIVEN FACE INSPECTION
Inspect the drive belt contacting surface of both driven faces for
any scratches, wear or damage. If any damages are found,
replace the driven faces with new ones.
REASSEMBLY
Reassemble the clutch shoe assembly and movable driven face
in the reverse order of disassembly. Pay attention to the follow-
ing points.
• Install the bearing 2 in the fixed driven face 1 with the spe-
cial tool.
$ 09943-88211: Bearing installer
• Apply SUZUKI SUPER GREASE "A" to the bearing 2.
* 99000-25010: SUZUKI SUPER GREASE "A"
• Securely install the snap ring.
• Install the bearing with the special tool.
$ 09924-84510: Bearing installer
NOTE:
Face the stamped side of the bearing out.
• Apply SUZUKI SUPER GREASE "A" between the sliding sur-
face of the fixed driven face and movable driven face.
* 99000-25010: SUZUKI SUPER GREASE "A"
NOTE:
When installing the movable face to the fixed face, make sure
the oil seal is positioned properly.
http://mototh.com