Engine Remounting - Suzuki UY125 Service Manual

3-8 ENGINE

ENGINE REMOUNTING

Remount the engine in the reverse order of removal. Pay atten-
tion to the following points:
• Install the crankcase bracket 1 to the frame and insert the
crankcase bracket mounting shaft.
• Push up on the rear part of the crankcase bracket 1 and
have the damper B touch the stopper A. While holding the
damper, tighten the engine mounting bracket nut 2 to the
specified torque.
" Crankcase bracket nut: 102 N·m (10.2 kgf-m)
• Install the engine and tighten the engine mounting nut 3 to
the specified torque.
" Engine mounting nut: 85 N·m (8.5 kgf-m)
NOTE:
When tightening the engine mounting nut, make sure that the
front wheel is elevated.
• Tighten the rear shock absorber lower mounting nut 4 to the
specified torque.
" Rear shock absorber mounting bolt: 29 N·m (2.9 kgf-m)
NOTE:
* Place 65 kg on the seat, after installing the engine.
* Check that clearance C and D are equal. If clearances C and
D are not equal, repeat the engine installation procedures.
• Install the crank case tube 5.
NOTE:
Set the crankcase tube E to the crankcase tube grommet F.
(!7-23)
http://mototh.com