Caliper Reassembly - Suzuki UY125 Service Manual

5-26 CHASSIS
CALIPER HOLDER
Inspect the caliper holder for damage. If any defects are found,
replace it with a new one.

CALIPER REASSEMBLY

Reassemble the brake caliper in the reverse order of disassem-
bly. Pay special attention to the following points:
Wash the caliper bores and pistons with the specified brake
fluid.
Thoroughly wash the dust seal grooves and piston seal grooves.
%
* Wash the brake caliper components with new brake
fluid before reassembly. Do not wipe the brake fluid
off after washing the components with a rag.
* Replace the removed piston seals and dust seals
with new ones. Apply brake fluid to all of the seals,
brake caliper bores and pistons before reassembly.
* Specification and classification: DOT 4
PISTON SEAL
• Install the piston seal and dust seal as shown.
BRAKE CALIPER HOLDER
• Apply SUZUKI SILICON GREASE to the brake caliper holder
pin.
+ 99000-25100: SUZUKI SILICONE GREASE
http://mototh.com