Specifications - Toro Z Master Professional 6000 Series Operator's Manual

Choke
Use the choke to start a cold engine. Pull the choke
knob up to engage it.
Blade-Control Switch (PTO)
Use the blade-control switch (PTO) to engage the
electric clutch and drive the mower blades. Pull the
switch up to engage the blades and release. To
disengage the blades, push the blade-control switch
(PTO) down or move a motion-control lever into the
N - position.
EUTRAL LOCK
Ignition Switch
This switch is used to start the mower engine and has
3 positions: S , R
TART UN
Motion-Control Levers
Use the motion-control levers to drive the machine
forward and reverse, and to turn either direction.
Neutral-Lock Position
Use the N -
EUTRAL LOCK
safety-interlock system to engage and to determine
the N position.
EUTRAL
Fuel-Shutoff Valve
Close the fuel-shutoff valve (under the seat) when
transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and
accessories is available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
, and O .
FF
position with the

Specifications

Note:
Specifications and design are subject to
change without notice.
Width:
Cutting width
Without Deck
Deflector Up
Deflector Down
Length:
Roll Bar - Up
Roll Bar - Down
Height:
Roll Bar - Up
179 cm (71 inches)
Weight:
Model
74902TE
16
122 cm (48 inches)
116 cm (46 inches)
137 cm (54 inches)
162 cm (64 inches)
201 cm (79 inches)
206 cm (81 inches)
Roll Bar - Down
119 cm (47 inches)
Weight
556 kg (1226 lb)