Product Overview; Specifications - Toro Recycler 20958 Operator's Manual

Figure 5
1. Dipstick
3. Wipe the dipstick clean with a clean cloth.
4. Insert the dipstick fully into the oil-fill tube.
5. Remove the dipstick and read the oil level on the
dipstick; refer to Figure 5.
•
If the oil is below the Add mark on the dipstick,
slowly pour a small amount of oil into the oil-fill
tube, wait 3 minutes, and then repeat steps 3
through 5 until the oil level is at the Full mark on
the dipstick.
•
If the oil is above the Full mark on the dipstick,
drain the excess oil until the oil level is at the Full
mark on the dipstick. To drain the excess oil, refer
to Changing the Engine Oil (page 15).
Important: If the oil level in the crankcase is too
low or too high and you run the engine, you may
damage the engine.
6. Install the dipstick into the oil-fill tube securely.
Important: Change the engine oil after the first 5
operating hours ; change it yearly thereafter. Refer
to Changing the Engine Oil (page 15).

Product Overview

1. Handle
2. Blade-control bar
3. Ignition switch
4. Fuel-tank cap
5. Oil fill/dipstick
6. Washout port (not shown) 13. Recoil-start handle
7. Spark plug
1. Grass bag
2. Side-discharge chute

Specifications

Model Weight
20958 41 kg
(90 lb)
6
Figure 6
8. Cutting-height lever (4)
9. Air filter
10. Side-discharge deflector
11. Bag-on-demand lever
12. Handle knob (2)
14. Control-bar lock
Figure 7
3. Battery charger
(electric-start models
only)
Length Width Height
150 cm 58 cm
(59 in) (23 in)
107 cm
(42 in)