Electrical Specifications; Internal Components - Oracle ZFS Installation Manual

Storage appliance
Hide thumbs Also See for ZFS:
Table of Contents

Advertisement

7120
There are four RJ-45 Gigabit Ethernet ports (NET0, NET1, NET2, NET3) located on the
motherboard that operate at 10/100/1000 Mbit/sec. These network interfaces must be
configured before use.

Electrical Specifications

The following list shows the electrical specifications for the 7120. Note that the power
dissipation numbers listed are the maximum rated power numbers for the power supply. The
numbers are not a rating of the actual power consumption of the appliance.
Connectors
Two C13 connectors which work on 110-220v outlets
Input
Nominal frequencies: 50/60Hz
Nominal voltage range: 100-120/200-240 VAC
Maximum current AC RMS: 13.8A @ 100 VAC
AC operating range: 90-264 VAC
Output
3.3 VDC STBY: 3.0A
+12 VDC: 86.7A
Power dissipation
Max power consumption: 1235.3 W
Max heat output: 4212 BTU/hr
Volt-Ampere rating: 1261 VA @ 240 VAC, 0.98P.F.

Internal Components

The chassis has the following boards installed.
Note: Field-replaceable units (FRU) should only be replaced by trained Oracle service
technicians.
PCIe Risers - Each riser supports two PCIe cards that are customer-replaceable. There are
two risers per system, each attached to the rear of the motherboard.
38
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02

Advertisement

Table of Contents
loading

Table of Contents