Table of Contents
Advertisement
ZS3-4 Controllers
With the heads of the four chassis locating pins protruding though the four keyed openings in
2
the mounting bracket, pull the mounting-bracket toward the front of the chassis until the
mounting-bracket clip locks into place with an audible click.
Verify that all mounting pins are securely fastened to the chassis.
3
Repeat to install the remaining mounting bracket on the other side of the chassis.
4
▼
Installing the Controller Chassis into the Rack Slide Rails
This procedure requires a minimum of two people because of the weight of the chassis.
Attempting this procedure alone could result in equipment damage or personal injury. Always
load equipment into rack from the bottom up.
If you are using a universal 19-inch cabinet, snap an M6 square cage nut into the top and bottom
1
holes of the location where you will be installing the rail plate as shown.
Position a slide rail assembly in your rack so that the brackets at each end of the slide rail
2
assembly are on the outside of the front and back rack posts. The following graphic illustrates
96
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02
Advertisement
Table of Contents
