Table of Contents
Advertisement
ZS3-2 Controllers
- Position each round cable cover horizontally over the hinges, and align the hinge connectors
with the hinges. Using your thumb, apply downward pressure on each hinge connector to snap
the hinge connector into place. Swing the cable covers down and press down on the cable cover
handle to lock them into the closed position.
Ensure that the six Velcro straps are threaded into the CMA.
4
To prevent the rack from tipping, ensure all anti-tilt devices on the rack are extended.
5
Extend the storage controller approximately 13 cm (5 inches) out of the front of the rack.
6
At the back of the rack, insert the CMA's connector A into the front slot on the left slide-rail until
7
it locks into place with an audible click (frames 1 and 2). The connector A tab (1) goes into the
slide-rail's front slot (2). Gently tug on the left side of the front slide bar to verify that connector
A is properly seated.
88
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02
Advertisement
Table of Contents
