Table of Contents
Advertisement
ZS3-2 Controllers
If necessary, bundle the cables with additional Velcro straps to ensure that they stay clear of
20
other equipment. If you need to install additional Velcro straps, wrap the straps around the
cables only, not around any of the CMA components; otherwise, expansion and contraction of
the CMA slide bars might be hindered when the server is extended from the rack and returned
to the rack.
▼
Verify Operation of Slide-Rails and CMA
Ensure all rack anti-tilt devices are extended to prevent the rack from tipping forward when the
1
storage controller is extended from the rack.
Slowly pull the storage controller out of the rack until the slide-rails reach their stops.
2
Inspect the attached cables for any binding or kinks.
3
Verify that the CMA extends fully with the slide-rails.
4
Push the storage controller back into the rack and verify that the CMA retracts without binding.
5
Adjust the cable straps and the CMA, as required.
6
▼
Removing the CMA
Ensure all rack anti-tilt devices are extended to prevent the rack from tipping forward when the
1
storage controller is extended from the rack.
To make it easier to remove the CMA, extend the storage controller approximately 13 cm (5
2
inches) out of the front of the rack.
To remove the cables from the CMA, do the following:
3
- Disconnect all cables from the rear of the storage controller.
- If applicable, remove any additional Velcro straps that were installed to bundle the cables.
- Unwrap the six Velcro straps that are securing the cables.
- Open the three cable covers to the fully opened position.
- Remove the cables from the CMA and set them aside.
To disconnect connector D, perform the following steps:
4
- Press the green release tab on the slide-rail latching bracket toward the left and slide the
connector D out of the left slide-rail. Support the CMA until the rest of the connectors are
disconnected. Do not allow the CMA to hang under its own weight.
92
Oracle ZFS Storage Appliance Installation Guide • January 2014 E48491–02
Advertisement
Table of Contents
