Table of Contents
Advertisement
Plug a power cord into each power supply with fan module.
1
Plug the other end of the power cords into the external power source for the cabinet.
2
Note: To guarantee redundancy, power cords must be connected to two separate and
independent power sources.
Supply power to the external power source.
3
Place the power supply on/off switches to the "I" on position.
4
Turn on the cabinet circuit breakers, if applicable.
5
After the disk shelf powers on, which could take several minutes, ensure that the system power
6
indicator on the front of the disk shelf is lit a steady green, and that each power supply with fan
module status indicator on the rear is lit a steady green. If not, power off the disk shelf as
described in the next section and reseat the faulted module. If the module status indicator is not
a steady green after module reinsertion, contact Oracle Customer Service.
Perform the software setup tasks as described in the storage controller installation guide.
7
▼
Powering Off the Disk Shelf
Most disk shelf components are hot-swappable; you do not need to remove power when
replacing them. Do not remove a component if you do not have an immediate replacement. The
disk shelf must not be operated without all components in place.
Chapter 2 • Installation
DE2 24C
125
Advertisement
Table of Contents
